At Klinik RC, our goal is to make life easier for RC racing enthusiasts!

Simplify and facilitate the charging of your receiver or transmitter (Futaba, for example). No need to run your balance cables outside the radio box, where they risk being damaged!

No need to open the radio case, keep it closed indefinitely!

Simply install the female connector in your battery box (a drill and/or Dremel grinder are required to make the opening), then connect it to the battery's balance connector.

And that's it! The male side simply plugs into any standard 2s balancing cable with a JST XH charging connector. Powerful north and south magnets ensure correct polarity while securely holding the charging cable in place while you prepare for your next race or run!

You can also install and use it with any transmitter that uses a 2S LiPo or LiFe battery. Use a single charging cable for both the radio and the cars! Simple and effective! *

*To do this, you need a charger that only charges 2S batteries through the balance plug.

(The female part is recessed several millimeters to prevent contact or short circuits between the terminals.)

Technical specifications:

• Male charging cord length: 10 inches (25 cm)
• Maximum current: 2A
• JST XH 3s balance connections
• Powerful N/S magnets for a secure one-way connection
• Universal, fits all manufacturers and scales