Aluminum steering servo mount for Team Associated B7|B6.4|B6.3 by Jconcepts, blue or black

The bracket fits snugly inside the chassis servo mounting area, for direct mounting to the chassis.

The brace has slots on each side for the included 3x6mm set screws to help align and maintain servo position during racing conditions, shock or stress.

The set screws are intended to touch the servo housing and provide additional support by holding the servo in the intended position, helping to maintain more direct and consistent steering.

The servo mounting bracket can be installed without any modifications or additional equipment in Team Associated B7, B6.4, B6.3 2wd buggies.

Installation notes:

• To install, completely remove the servo from the car and remove the original brackets.
• With the servo horn already in the correct position, align the servo using the plastic shims.
• Install brace on each side and loosely attach factory mounting screws with washers in all 4 locations and tighten.
• Now center the servo between the brace and install the 3x6mm set screws on each side, use a small amount of thread locker and tighten to touch and hold the servo in place.
• Fully tighten the 4 mounting screws on the front panel to lock the position of the servo. Remember to always use a small amount of thread locking compound when fastening steel screws into aluminum.
• Reinstall the servo on the vehicle
• Check the EPA settings (limit switches) to complete the assembly.